Schéma bracelet « Julia »

Matériel :

1 Sachet Arcos@par Puca®(A), 1sachet de Minos®par Puca®(M),rocailles

15, et 11(R), 2 R8 + Fermoir.Vous êtes prêtes ?

Vous venez de terminer le bracelet Julia.

Merci de respecter mon travail. Schéma a usage personnel.

Je vous souhaite un agréable perlage. Schéma ®

Puca … Le 02 Avril 2016

English translation for the Julia bracelet by Puca Translation by Leslie Rogalski

30 Arcos(R)par Puca (for 7-in 18cm bracelet) 32 Minos(R) par Puca.5g 15/0 seed beads 1g 11/0 seed beads2 size 8/0 seed beads (or two closed jump rings, see Step 7)clasp (plus open jump rings to attach, see Step 7)

IMPORTANT: Refer to the photos to see through which holes you sew and the bead orientation.

1. Pick up an Arcos, two 15s, an 11, and two 15s. Sew through the Arcos.2. Pick up a 15, a Minos, a 15 and an Arcos.3. Pick up a15, a Minos, and a 15. Sew through the previous Arcos.4. Sew through the three beads strung in Step 2 and the second Arcos again.5. Pick up two 15s, an 11, and two 15s. Sew trough the open hole of the Arcos.6. Repeat from Step 2-5 for desired length.7. You get this, for an 18 cm (7-in) bracelet use 15 Arcos8. Pick up an 11, an 8, an 11 and an Arcos. Editor’s note: this method strings a jump ring

through the size 8 bead to attach your clasp. An option is to string a closed jump ring insteadof an 8, and use an open jump ring to attach your clasp to the closed ring.

9. Continue like this, from Step 2 etc for the second side o your bracelet.10. At the other end repeat Step 8 for the other part of your clasp.11. Sew through the Arcos, the 5 seed beads on top, back through the other hole of the same Arcos, and

exit through the 15, Minos and 15 as shown.12. Pick up a Minos and sew through the 15, Minos, and 15, starting a flat RAW stitch.13. Pick up a Minos and complete the RAW stitch, sewing through the 15, Minos and 15.14. Sew through the next Arcos and seed beads as in Step 11 to sit the next Minos.15. Repeat, working a flat RAW stitch to add Minos beads and sewing through the Arcos beads, attaching

the two sides of the bracelet.16. When you reach the end, weave in your threads to secure. Trim.

Bravo! You made the " Julia " bracelet of Puca® . Thank you for respecting my work. For personal use only. I wish you a pleasant beading. Puca® April 14, 2016 .