NT-3200

INSTRUCTION MANUAL

MINI POCKET TESTER WITH VARIOUS ADAPTORS

�

Thank you for purchasing the Pro’sKit’ Mini Pocket Tester with various adaptors. The unit is a Mini Pocket Tester for identify-ing cables in a Multi Dwelling Unit. The cable installer uses the unit to place a DC current through one end of the desired cable and identifies the cable at the end with the detachable Tone Detector. Before using the Mini Pocket Tester and vari-ous adaptors, please read the following manual completely.

Features and BenefitsTones out cables by inserting a DC current into a coaxial cable at one end and detects that cable from others in a remote loca-tion by attaching the audio toning detector to the other end.

Features • Improved head design with rugged push-on male F connector • Easily viewable short circuit indicator • Loud audio level for noisy environments • Time-saving push-on female connector on audible toner • Easily stores in shirt pocket or tool pouch

The unit is equipped with a short circuit detector. The LED is located on the head of the transmitter section. If a DC short circuit exists in the cable, the LED will light up. Many high qual-ity splitters used for MDU application are short circuit to DC; therefore, if these splitters are in the cable line, the LED will light up. With the additional wide range of optional adaptors, it can test telephone, LAN, audio, security, or virtually any other type of wire or cable easily.

Contents• NT-30� Mini Pocket Tester • � x RJ45 to F male• � x F-type female to BNC female • � x RJ11 to F male• � x F-type male to F-type male • � x F-type female to RCA male• � x BNC female to F-type male • � x F female to PAL Female• � x RCA female to F-type male • � x F female to F Push-on male• � x F-type female to BNC male• 1 x F-type female to F-type female

3

Short circuit LED

Male F type push-on fitting

Main section

Battery chamber access cap

Detachable tone detector

Warning: This tool should never be used on live electrical circuits. It is not protected against electric shock!Always use OSHA/ANSI or other industry approved eye protection when using tools. This tool is not to be used for purposes other than intended. Read carefully and un-derstand instructions before using this tool!

4

OPERATING INSTRUCTIONS123456

Tone detector

F male to RCA female

RCA cable F male to RCA female

F double connector

NT-302Common use for cable testing instruction:1. Take the NT-30� mini pocket tester, then unscrew the “tone”

detector which is conveniently stored in the base section�. Put a double female “F” connectors into the top of NT-30�

push-on fitting port, and put another type of connector which one end matching the desired test cable plug.

3. Connect the connector with desired test cable properly4. Add a type of connector which matches both ends of de-

sired test cable end plug and the “tone” detector5. Put the “tone” detector to the matching connector6. When the desired test cable short circuit was found, the

LED lights up and the tone will sound Cable in an MDU testing instruction: 1. Take the NT-30� Mini Pocket Tester, then unscrew the

“tone” detector which is conveniently stored in the base section

2. The main section of NT-302 has a male “F” push-on fitting. Attach this push-on fitting to a female “F” port on an apart-ment wall plate.

3. Tough the “tone” detector to each one of the cables at the remote location. When the correct cable from the transmit-ter location is found, the tone will sound.

Note: To replace the battery, unscrew the battery chamberaccess cap above the tone detector. Battery type: �3A-1�V

5

BNC cable � (Assembly)

Notice: If you test other cables, please follow below SOP for reference.

SOP (Steps of procedure)

BNC cable 1 (Parts)

RCA cable � (Assembly)RCA cable 1 (Parts)

�

感謝您購買Pro’skit NT-3�00 測試筆組。NT-3�00測試筆組是一個能偵測多住宅用戶(MDU)纜線的迷你型測試筆組。纜線安裝人員可使用NT-3�00測試筆組於纜線一端接上直流電，並在電纜另一端利用可拆式蜂鳴器偵測結果。使用Pro’sKit NT-3�00測試筆組前，請先詳細閱讀以下說明。

功能與特點：將直流電接上同軸纜線的一端，並在另一端接上蜂鳴器即可遠距離偵測纜線。

特點：•先進的前端設計與堅固耐用的快速拔插F接頭•可輕鬆辨識的短路指示燈•音頻信號方便於吵雜環境使用•L型筆管上的快速F插頭可節省工作時間•可輕鬆收納於襯衫口袋或工具袋

Pro’skit NT-3�00測試筆組於測試器前端配備了短路探測器 - LED燈。如果直流電發生短路，LED燈便會發亮。許多應用在多住宅用戶(MDU)的高品質分離器屬於短路直流電，因此，如果這些分配器是在電纜線路上，LED燈便會發亮。有了這項附加的測試器，便可輕鬆且大範圍地運用在測試電話、網路、音頻信號、安全或幾乎任何類型的電線或電纜上。

�

內容物：• NT-30� Cable測試筆

• � × F母接頭轉BNC母接頭

• � × F公接頭轉F公接頭

• � × BNC母接頭轉F公接頭

• � × RCA母接頭轉F公接頭

• � × F母接頭轉BNC公接頭

• � × RJ45接頭轉F公接頭

• � × RJ11接頭轉F公接頭

• � × F母接頭轉RCA公接頭

• � × F母接頭轉PAL母接頭

• � × F母接頭轉快速拔插F接頭

• 1 × F母接頭轉F母接頭

10

LED短路指示燈

快速F公接頭裝置

主體

電池鎖蓋

可拆式蜂鳴器

警告： 這個工具絕不能在有電的線路上使用。功具本身並無防觸電設計！

11

操作說明：

電纜測試使用說明：1. 拿出NT-30� Cable測試筆，並將蜂鳴器拆下（蜂

鳴器可收納於底部）。 �. 將F母雙接頭插入NT-30�前端插口，並插入其他

可與另一端纜線插頭結合的接頭。3. 結合接頭與纜線。4. 加上可與測試纜線雙頭結合的接頭與蜂鳴器。5. 將蜂鳴器與接頭結合。6. 當發現測試纜線短路，LED燈便會發亮且蜂鳴器

會發出聲響。

MDU纜線測試使用說明：1. 拿出NT-30� Cable測試筆，並將蜂鳴器拆下（蜂

鳴器可收納於底部）。�. NT-30�主體部份有一F母接頭裝置，將此裝置與

公寓外牆板的F插孔結合。3. 於遠端將音頻探測器與任一電纜接合，當偵測到

正確的纜線，蜂鳴器將發出聲響。

備註：若要替換電池，請鬆開蜂鳴器上方放置電池處的蓋子即可。電池種類：23A-12V電池

123456

蜂鳴器 F公接頭轉RCA母接頭

RCA電纜 F公接頭轉RCA母接頭

F接頭

NT-30� Cable測試筆

1�

BNC cable � (裝配圖)

BNC cable 1 (零件圖)

備註:如果您要測試其它纜線，請參考下列SOP步驟說明SOP(標準作業程序)

13

RCA cable � (裝配圖)

RCA cable 1 (零件圖)

14

RJ-45 (1) RJ-45 (�)

RJ-45 (3) RJ-45 (4)

15

RJ-11 (1) RJ-11 (�)

RJ-11 (3) RJ-11 (4)

Prokit’s Industries Co., Ltd.寶 工 實 業 股 份 有 限 公 司5F, No.�, Lane 130, Ming-Chung Rd., Hsin-Tien City, Taipei Hsien, Taiwan, R.O.C. Post code: �3114

� 3 1 台 北 縣 新 店 市 民 權 路 1 3 0 巷 � 號 5 樓

Tel: ��6-�-��1�3�33 (Rep.) Fax: ��6-�-��1�����E-mail:pk@mail.prokits.com.tw http://www.prokits.com.tw